Technical data QN connectors

Electrical data	Requirements
Impedance	50
Frequency range	DC to 6 GHz (optimized) DC to 11 GHz (working range)
Dielectric withstanding voltage 1	2'500
Working voltage 1	1'000
Insulation resistance	5 x 103 M
Contact resistance - centre contact	1.5m
- outer contact	1.5m
RF-Leakage	100 MHz to 3 GHz -90 dB
Return loss (typical)	DC - 3 GHz 32 dB; 3 to 6 GHz 25 dB; 6 to 11 GHz 20 dB
Intermodulation	better -155 dBc (2 x 43 dBm carrier)

¹ at sea level, in V rms, 50 Hz

Mechanical data	Requirements
Durability (matings)	100
Engagement force (typ.)	30 N / 6.7 lbs
Disengagement force (typ.)	30 N / 6.7 lbs
Retention force for interface	450 N / 101.2 lbs
Bend.moment admis.2	10 Nm / 88.5 in. lbs
Contact captivation	28 N / 6.3 lbs

² interface

Enviromental data	Test conditions
Temperature range	-40°C ... +125°C / - 40° F ... + 257° F
Climatic category	40 / 125 / 21 (IEC 60169_1 16.2)
Moisture resistance	MIL–STD–202 F, Method 106 F
Corrosion	Salt spray test acc. to MIL–STD–202 F, method 101 D, condition B
Vibration	IEC-1169-1 paragraph 9.3.3. (10-500 Hz; 5g)
Shock	MIL–STD–202 F, Method 213, Condition I
Rapid change of temperature	IEC 60169-1 16.4 (-40°C ... +125°C / - 40° F ... + 257° F )
Water resistance	IP 68

Material data
Connector part	Material	Plating
Bodies	brass	SUCOPLATE®
Pin contacts	brass	SUCOPRO
Socket contacts	spring bronze	SUCOPRO
Insulators	typ.: PTFE or PFA
Contact washer	spring bronze or copper beryllium	SUCOPRO

Some connectors may feature specifications that differ from the above mentioned data.

The products are designed and guaranteed to pass the above mentioned test procedures. Any additional or different requirement arising from specific applications or environmental conditions which is not covered by these test procedures is subject to request.