Reverse polarity connectors

According US FCC (Part 15.203) regulations, wireless radio equipment with removable antenna must not have a standardized interface. This to avoid the connection of antenna equipment which is not WLAN approved.

An established solution is the so called reverse polarity connectors. That means, the male connector is fitted with female center contact and insulator, whereas the female side is fitted with male center contact and insulator. For identification of reverse connectors the letter R (for reverse) is used in the type description.
Example: 11_TNC-R50-3-42.

Cable connectors series TNC

Straight cable plugs (reverse)

for flexible cables
cable attachment: HUBER+SUHNER® full crimp

Straight cable jacks (reverse)

for flexible cables
cable attachment: HUBER+SUHNER® full crimp

Straight bulkhead cable jacks (reverse)

for flexible cables
cable attachment: HUBER+SUHNER® full crimp
with panel seal
mounting hole ML4

Cable Connectors Series SMA

Straight cable plugs (reverse)

for flexible cables
cable attachment: center contact soldered / outer contact crimp

Right angle cable plugs (reverse)

for flexible cables
cable attachment: center contact soldered / outer contact crimp

Straight cable jacks (reverse)

for flexible cables
cable attachment: center contact soldered / outer contact crimp

Straight bulkhead cable jacks (reverse)

for flexible cables
cable attachment: center contact soldered / outer contact crimp
with panel seal
mounting hole ML35

Termination series SMA

50 Ω, plug (reverse)
1 watt
DC-6 GHz

Adaptors

straight
plug (reverse) to jack (standard)

angle
plug (reverse) to jack (standard)